Electronics

Electronics

Solder fumes from soldering using rosin-cored solder may cause asthma.  You should always try and prevent exposure to any substances that may cause asthma. If that is not reasonably practicable, control short and long term exposures to prevent asthma developing by installing LEV (local exhaust ventilation or fume extraction).  If an individual develops occupational asthma, even very low levels of solder fumes in the air can trigger an attack.

When solder flux is heated above 183 Deg. C, (or higher for Lead Free) a complex mixture of resin acid particulates (smoke) and gases are generated - this is called ‘COLOPHONY’ and is produced from Hand Soldering, Solder Pots and Fountains, Wave Solder machines and Reflow Ovens

To fully understand the problem, we need to understand what makes up a typical rosin based solder fume. A typical solder fume is a mix of very small particles (smoke) and gases which can be explained as around 95% particulates (the physical smoke plume), and around 5% gases and vapours which can contain a cocktail of Acetones, Methyl Alcohol, Formaldehyde, Carbon Dioxide, Diterpine Acid, Carbon Monoxide and Isopropyl Alcohol.  Note: Even ‘Synthetic’ and ‘No Clean’ fluxes can lead to serious lung irritation

Once inhaled, the lungs cannot easily remove particle sizes under 10 microns.  If you knew a human hair is approximately 100 microns in diameter, consider this – the largest solder fume particle is around 10 microns in diameter and the smallest is around 0.3 microns (you can only see 30 microns with a naked eye).

Inhalation of hazardous fumes causes many symptoms that include headaches, runny eyes and nose, sore throat, respiratory problems, asthma, dermatitis and acne, nose bleeds and even some can be carcinogenic (causes cancers). Some of these symptoms can occur several hours after exposure when at home watching television, and are not associated with work.  This is called a ‘late asthmatic reaction’ and is often blamed on an allergy to the pet cat or dog !

Inhalation of hazardous fumes do also result in the unseen problems of reduced productivity and absenteeism, re-recruiting and re-training costs, operator compensation claims/litigation – many cases are well documented.

Assessing exposure to Solder Fumes - Colophony (in the UK)

The UK has assigned occupational exposure limits for rosin based solder fumes as follows

A special method of sampling (MDHS 83) is used to measure the ’resin acids’ in the fume.  The Max Exposure Limit is set at:  0.05 mg/m3 as an 8 hour TWA and 0.15mg/m3 over 15 mins.                   

Note: Older lapel sampling methods do not provide accurate results.

It was found recently by the HSE themselves that even a ‘moderate amount’ of soldering when not extracted caused exposures over 50 times greater than the 8-hour Workplace Exposure Limit of 0.05 mgm-3 and over 30 times greater than the 15-minute Short Term Exposure Limit of 0.15 mgm-3.

Sort By:
Show:
BOFA AD2000 iQ Extraction System
** Quote Required for Est. Shipping Costs - Please Provide Us With Your Shipping Address**The ..
BOFA DustPRO 250 Extraction System
The BOFA DustPRO 250 Extraction System has been developed for the safe and effective removal of dust..
BOFA DustPRO 400 Extraction System
The BOFA DustPRO 400 Extraction System is a compact and powerful dust extraction solution. The BOFA ..
BOFA FumeCAB 250
The BOFA FumeCAB 250 is a small, bench top extraction system designed for a..
BOFA FumeCAB 600
The BOFA FumeCAB 600 is a bench top fume extractino solution for low..
BOFA T1 Tip Extraction Unit
The BOFA T1 is a high vacuum, tip extraction unit for solder fume. Tip extraction is designed to rem..
BOFA T15 Tip Extraction Unit
The BOFA  T15 is a high vacuum, tip extraction unit for solder fume for up to .  The BOFA ..
BOFA T30A Tip Extraction Unit
** Quote Required for Est. Shipping Costs - Please Provide Us With Your Shipping Address**The BOFA T..
BOFA TVT2 Tip Extraction Unit
The BOFA TVT2 is a quiet and compact high vacuum, tip extraction unit which runs on 6..
BOFA V Oracle SAiQ High Volume Extraction Unit
BOFA’s most technically advanced compact fume extractor designed specifically to m..
BOFA V1000 iQ High Volume Extraction Unit
** Quote Required for Est. Shipping Costs - Please Provide Us With Your Shipping Address**The BOFA V..
BOFA V1500 iQ High Volume Extraction Unit
** Quote Required for Est. Shipping Costs - Please Provide Us With Your Shipping Address**The BOFA V..
BOFA V200 Single User Arm Extraction System
The BOFA V200 Single User Arm Extraction System has been designed primarily to extract adhesive vapo..
BOFA V2000 iQ High Volume Extraction System
** Quote Required for Est. Shipping Costs - Please Provide Us With Your Shipping Address**The ..
BOFA V250 Dual Arm Extraction System
The BOFA V250 Dual Arm Extraction System has been designed primarily to extract the fumes generated ..
BOFA V4000 High Volume Extraction Unit
** Quote Required for Est. Shipping Costs - Please Provide Us With Your Shipping Address**The ..
Showing 1 to 16 of 22 (2 Pages)
Quick Filter
Price
£ £